Deerc De22 Drone Manual Pdf (2025)

FAQs

How do I connect my phone to my Deerc drone? ›

Enter your phone's Wi-Fi settings and click Wi-Fi to search for the Wi-Fi of the drone. (Make sure to turn on the drone before going to the Wi-Fi settings on your phone) ② Select the Wi-Fi network: DeercFPV-******. ③ Wait for a couple of seconds for your phone to connect to the drone's Wi-Fi.

If the drone tends to drift right, hold down the “Speed Switch” button and do not release it while pushing the direction joystick left to re-balance the drone. Take Photo: Short press the Photo button on the transmitter to take pictures.

① Clean the drone after each use with a clean, soft cloth. ② Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone or batteries. ③ This device is not waterproof and must not be submerged or subjected to water under any circumstance.

You may need to press and hold the drone's power button for 4 seconds until it starts to beep, and then tap the "Pair" button on the app. Calibrate the IMU and compass of your drone using the DJI Fly app. Check whether you are in a no-fly zone or a restricted area that may interfere with the drone's signal.

One of the most reliable ways to fly your drone without an internet connection is by using a dedicated remote controller. These controllers are designed specifically for your drone model and use proprietary communication protocols to establish a direct link between the controller and the drone.

The battery life is probably a solid 10 mins. It comes with two batteries and it takes about 90min to charge.

Always store batteries in a well-ventilated area away from direct sunlight and heat sources. Remove the batteries from the drones when storing them. Do not allow the batteries to get wet. It is not recommended to recharge your batteries to 100% before storing them.

Generally, it's not recommended to fly drones in rain, mist, high humidity, or over water bodies with strong winds. Many drones have venting holes that can expose the electronics inside to moisture. Once water gets inside, short circuits can occur and possibly damage your drone.

Typically, you'll either press a button on the controller, perform a specific stick movement, or use a mobile app to enable headless mode – just make sure to set your drone's initial orientation before taking off.

How do I activate my drone mobile? ›

Download the DroneMobile app in the App Store or Google Play. Input your serial number (found on your hangtag, keychain tag, or sticker) and click “Continue.” Fill out personal info and click “Submit.” Check your email to verify your account and create your DroneMobile password.